Section Vi. Stainless Steel Face Ring Assy. Instructions; Section Vii. Sam Spectrum Amerlite Replacement Parts - Pentair Water Pool and Spa SAm Manual Del Propietário

Section VI. Stainless Steel Face Ring Assy.
Instructions
1. Replace lens gasket. A NEW LENS GASKET
MUST BE USED EACH TIME THE LIGHT IS
REASSEMBLED.
2. With the light resting on its base, place lens/gasket
assembly on light fixture and position so the white
pointer on the color wheel/bulb assembly points to the
"O" in the word "TOP" on the surface of the lens. See
Figure 2.
3. Align the special pilot screw on the face ring with the
letter "O" of the word "TOP" on the surface of the
lens. The pilot screw, "O" in "TOP" and the white
pointer on the color wheel/bulb assembly should also
align with the cord compression fitting on the top rear
of the light fixture.
4. With the bent ends of the circular uni-tension clamp
pointing down spread the clamp and place it in the "U"
recesses of the locking levers. Be sure the bent ends of the clamp are located between the pair of locking
levers as shown in Figure 4, location A. Check to see that the clamp is properly engaged with all of the levers.
5. Turn the light so that it is now resting on its lens. Tighten the screw and nut until the distance between the
ends of the clamp equals 1/4 inch (0.6cm) or less; see Figure 5.
Section VII. SAm Spectrum Amerlite
®
5
6
P/N • Núm/Pte. • Réf. P/N 619587
Replacement Parts
®
1
Item
No.
2
1 79212100
1 79212165
1 79212111
3
2 79104800
2
3 79110600
4
4 79111000
5
6 79101600
7
8 79112400
7
8
SAVE THESE INSTRUCTIONS.
Figure 4.
Figure 5.
Part No. Description
Face ring, large plastic, white
Face ring, large plastic, gray
Face ring, large plastic, black
Pilot Screw, with captive gum washer, brass
619355 Pilot Screw, with captive gum washer, S/S
Face ring assembly, S/S
Uni-tension wire clamp assembly
619385 Lens, SAm, standard
Gasket, 8-3/8 in. lens
619487 Nut, retaining
Bulb, 71 watt, EYC, MR-16, 2 req.
NOT SHOWN
619489 Colorwheel assembly
619495 Colorwheel motor w/gear
8
(0.6cm)
45 degrees
Bolt and nut are to be tightened at approx. 45 degrees
from the pilot screw between the tabs on the face ring
as shown above.
Rev. B • Rev. B • Rév. B 10-29-07
A