Graco IronMan 300E Manual De Funcionamiento Y Lista De Piezas página 27

TYPE OF PROBLEM
Pump output is low
Motor runs but pump does not
stroke
Excessive paint leakage into
throat packing nut
Fluid is spitting from gun
Pump is difficult to prime
313314D
WHAT TO CHECK
If check is OK, go to next check
14. O-ring in pump is worn or damaged
15. Intake valve ball is packed
with material
16. Pressure setting is too low
17. Large pressure drop in hose
with heavy materials
1. Displacement pump pin (32)
damaged or missing; see pump
manual 310643.
2. Connecting rod assembly (43)
damaged; see pump manual
310643.
3. Gears or drive housing damaged,
page 71.
1. Throat packing nut is loose
2. Throat packings are worn
or damaged
3. Displacement rod is worn
or damaged
1. Air in pump or hose
2. Tip is partially clogged
3. Fluid supply is low or empty
1. Air in pump or hose
2. Intake valve is leaking
3. Pump packings are worn
4. Paint is too thick
Repair / Réparation / Reparación
WHAT TO DO
When check is not OK, refer to this column
14. Replace o-ring; see pump manual 310643.
15. Clean intake valve; see pump manual 310643.
16. Increase pressure.
17. Use larger diameter hose and/or reduce overall
length of hose. Use of more than 100 ft of 1/4 in.
hose significantly reduces performance
of sprayer. Use 3/8 in. hose for optimum
performance (50 ft minimum).
1. Replace pump pin if missing. Be sure retainer
spring (31) is fully in groove all around
connecting rod; see pump manual 310643.
2. Replace connecting rod assembly; see pump
manual 310643.
3. Inspect drive housing assembly and gears for
damage and replace if necessary; see pump
manual 310643.
1. Remove throat packing nut spacer. Tighten
throat packing nut just enough to stop leakage.
2. Replace packings; see pump manual 310643.
3. Replace rod; see pump manual 310643.
1. Check and tighten all fluid connections.
Reduce engine speed and cycle pump
as slowly as possible during priming.
2. Clear tip; see tip guard manual 309640.
3. Refill fluid supply. Prime pump; see pump
manual 310643. Check fluid supply often
to prevent running pump dry.
1. Check and tighten all fluid connections.
Reduce engine speed and cycle pump
as slowly as possible during priming.
2. Clean intake valve. Be sure ball seat is not
nicked or worn and that ball seats well.
Reassemble valve.
3. Replace pump packings; see pump manual
310643.
4. Thin the paint according to the supplier's
recommendations.
27