Installation And Initial Start-Up; Unpacking And Checking The Contents; Selecting The Location; Assembly - Ivoclar Vivadent Programat CS Manual De Instrucciones

4.1 Unpacking and checking the
contents
The packaging provides the following advantages:
– Reusable packaging
– Closing mechanism with integrated transporta-
tion grips
– Ideal protection by Styrofoam inserts
– Easy handling / optimum unpacking
– The packaging may be used in several ways
(modules)
Check the delivery for completeness (see delivery
form in Chapter 9) and transportation damage. If
parts are damaged or missing, contact your local
Ivoclar Vivadent Service Center.
Remove the furnace components from their
packaging and place it on a suitable table. Please
observe the instructions on the outer packaging.
There are no special transportation grips on the
furnace. Support the bottom of the furnace to
carry it.
Packing and shipping of individual
components:
The packaging of the Programat CS permits simple
and safe shipping of individual components. Simply
use the two corresponding inserts. Fold the side
flaps (2) and combine the two packaging parts by
means of the transportation flaps. The packaging
may be disposed with the regular household
refuse.
We recommend keeping the original
packaging for future service and
transportation purposes.

4. Installation and Initial Start-Up

4.2 Selecting the location

Place the furnace on a flat table using the rubber
feet. Make sure that the furnace is not placed in
the immediate vicinity of heaters or other sources
of heat. Make sure that air may properly circulate
between the wall and the furnace.
Also ensure that there is enough space between
the furnace and the user, as the furnace releases
heat during the opening of the furnace head.
The furnace should neither be placed nor
operated in areas where there is an explosion
hazard.

4.3 Assembly

Make sure the voltage indicated on the rating
plate (19) complies with the local power supply. If
this is not the case, the furnace must not be
connected.
Step 1:
Assembling the cooling tray (34)
Remove both screws (35) including the silicone washer (47) for the
cooling tray (34).
35
47
13
19
35
47