Function - Franke AQCT0043 Instrucciones De Montaje Y Uso

☞
The battery compartment and/or the power supply and extension cables are not
included (see Accessories,
☞
If an in-wall power supply is used, it must be installed about 3 m away from the
washing unit.
10.12 Connect the AQUACONTACT sensor to
– a battery compartment (m)
or
– an in-wall mounted power supply (n).
☞
When the battery charge level is too low, the LED flashes with a 20s cycle.
10.13 Using an Allen key, open the water volume regulator.
o: closed
p: open
10.14 Check the water connections for leaks.
10.15 Pull off the protective film from the shower panel.
10.16 Seal the shower panel with RoChromol (not included, see accessories
10.17 Hook-in the cover plate (r) on to the top of the tongues in the frame and attach.
10.18 Use the screws (q) to fix the cover plate at the bottom.
☞
Important!
Ensure that the tube is not kinked.

11. Function

☞
The remote control (not included, see Accessories
select the operating mode time-controlled/body reflection.
Triggering time-controlled
Trigger water flow
11.1 Allow your hand to approach the sensor.
• Water flows.
• Water flow stops automatically after the set flow duration or when your hand
approaches the sensor again.
☞
The flow duration has been factory set to 30s.
Triggering body-reflection
Trigger water flow
11.2 Allow your hand to approach the sensor.
• Water flows.
• Water flow stops automatically after you leave the sensor area, but no later than
after 5 minutes.
Chapter 16).
Chapter 16) can be used to
Chapter 19).
7