Pari Trek S Instrucciones De Uso página 7

D. TREK S SETUP (CONTINUED)
®
You are 10 Steps away from starting your treatment with
Trek S. Please follow step by step.
®
1. Clean/Disinfect Nebulizer Cup:
properly clean and/or disinfect your nebulizer prior
to first use. Re-assemble nebulizer.
2. Set-up Compressor: Place the compressor on a flat,
stable surface free of dust. Do not operate the
compressor while it is in the carry case or covered,
as this can cause excessive heat buildup in the
compressor housing. Avoid cushioned, upholstered or
carpeted surfaces. Make sure power switch is turned
"OFF" .
3. Connect Tubing To Compressor:
Wing Tip ® tubing to the air outlet on the compressor.
It should fit snugly (Fig. F).
4. Load Medication: Open the inspiratory valve cap
of nebulizer by lifting the cap (Fig. G). Pour the
prescribed dose of medication into nebulizer cup.
Never fill past the max. fill line of 8 ml.
5. Attach Mouthpiece or Mask:
attach the mouthpiece to the nebulizer outlet
with the expiratory valve facing up. Then close
the inspiratory valve cap by pressing firmly on the
nebulizer top. If using a mask, refer to the mask
instructions for use.
6. Attach Tubing To Nebulizer Cup:
end of the Wing Tip tubing to bottom of PARI
®
reusable nebulizer (Fig. H).
7. Starting Treatment: Sit in a relaxed, upright position and
turn the compressor "ON"
F
H
Refer to Sections E-F to
Insert one end of
If using the mouthpiece,
Firmly press the other
.
Questions? 1.800.FAST.NEB (327.8632) | PARI.com/TrekS
8. Nebulizer Position: Place the mouthpiece on top of
tongue and close lips around it. Take slow, deep
breaths. As you inhale, the inhalation valve opens.
9. Breathing: For mouthpiece, inhale and exhale slowly
through your mouth. As you exhale, the valve on
the mouthpiece opens to allow the exhaled mist to
escape. For mask, place mask over nose and mouth
and inhale and exhale slowly.
10. Complete Treatment: Continue until the medication
is gone or you hear a slight "sputtering" sound. Turn
compressor "OFF" .
NOTE: The PARI TREK
® S Compressor is protected by an
automatic resettable thermal switch. If the PARI TREK
S Compressor has reached its temperature limit, it will
automatically turn off to prevent damage to the compressor.
In the unlikely event this occurs, switch off the PARI Trek
S Compressor, ensure it is on a flat, stable surface and is
not covered, and allow the compressor to cool down. If the
PARI Trek S Compressor is not manually switched off, it will
®
automatically restart when the compressor cools.
The PARI TREK S Compressor may need approximately 30
®
minutes to cool down prior to resuming the treatment. If the
PARI TREK S Compressor does not start after it is switched on
®
after cooling for 30 minutes, please switch it off, allow another
few minutes for the compressor to cool, and try again. If you
need to use the PARI Trek S Compressor for longer than 30
®
minutes, please contact PARI at 1.800.FAST.NEB (327.8632).
G
®
®
EN-6