Home Decorators Collection CARLISLE 51760 Manual Del Usuario página 12

Assembly - Attaching the Light
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
□
Remove three screws (PP) from the the switch cup cover of
light kit fitter assembly (F) and save them for later use.
□
Connect the blue wire exiting the bottom of the fan motor
assembly (E) with black wire from the top of the light kit
fitter assembly (F).
□
Connect the white wire exiting the bottom of the fan motor
assembly (E) with white wire from the top of the light kit
fitter assembly (F).
□
Push the light kit fitter assembly (F) up to the switch cup
below the fan motor assembly (E), align the three screw
holes on the switch cup with the three screw holes on the
switch cup cover of the light kit fitter assembly (F).
□
Re-install the three screws that was removed in step 1.
make sure all the screws are firmly tightened.
2
Installing the light bulbs and
light kit cage
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
□
With power off, install the four LED bulbs (I) (Max. 6W,
included) by screwing into the light bulb sockets.
□
Insert the light kit cage to the light kit cowling by aligning
the three holes on the light kit cowling of the light kit fitter
assembly (F) with the three posts on the light kit cage (J),
screw the knurl nut (CC) into the posts of the light kit cage
(J) and hand tighten each nut.
F
I
J
12
E
PP
F
CC