Replacing The Side Panels; Reversing The Front Door (Optional) - Dell PowerEdge 4210 Guia De Instalacion

2 Allow the side panel to swing outward slightly from the bottom.
3 Grasp the panel firmly using the handles.
4 Lift the panel upward until it clears the top of the rack (see Figure 1-4).
5 Pull the side panel away from the rack.
CAUTION:
attempt to remove or install them by yourself.
6 Place the panel in a safe location with the panel's outer surface facing
upward.
Placing the panel with the outer surface facing upward helps prevent
damage to its cosmetic coating.
7 Repeat step 1 through step 6 for the other side panel.

Replacing the Side Panels

CAUTION:
attempt to remove or install them by yourself.
To replace the side panels, perform the removal steps in reverse.

Reversing the Front Door (optional)

NOTE:
Use a 4-mm Allen wrench to remove the front-door hinge bodies from the
rack and reinstall them on the side opposite their original positions. You might need
a stepladder in order to access the Allen bolt that secures the top hinge body to the
rack.
To reverse the direction that the front door opens, complete the following
steps:
1 Remove the front door. For instructions, see "Removing the Front Door."
2 Remove the side panels. For instructions, see "Removing the Side Panels."
3 Reverse the top hinge body.
Pull the hinge pin upward slightly so that you can access the retention
a
clip (see Figure 1-5).
Using the needle-nose pliers, remove the retention clip, and slide the
b
hinge pin out of the hinge body.
14
Dell™ PowerEdge™ 4210 Installation Guide
Because of the size and weight of the rack cabinet side panels, never
Because of the size and weight of the rack cabinet side panels, never