Safety
3. Safety
This section describes the safety warnings and the Personal Protective Equipment used in the unit.
3.1. Safety conditions
General warnings
The operations described in the manual may be performed only by qualified personnel.
The status of qualified personnel referred to in this manual will be, as a minimum, that which meets
all the standards, regulations and laws regarding safety applicable to the tasks of installing and
operating this unit.
All applicable safety-related legislation for electrical work must be complied with. Danger of electric
shock.
Compliance with the safety instructions set out in this manual or in the suggested legislation does
not imply exemption from other specific standards for the installation, place, country or other
circumstances that affect the unit.
Opening the door of the housing does not imply there is no voltage inside. Only qualified personnel
may open it.
The risk of electric shock exists even after disconnecting from the grid.
The entire manual must be read and understood in full prior to manipulating, installing or operating
the unit.
Following is a list of the basic obligatory safety standards for each country:
•
RD 614/2001 in Spain.
•
CEI 11-27 in Italy.
•
DIN VDE 0105-100 and DIN VDE 1000-10 in Germany.
•
UTE C18-510 in France.
Category III - 1000-Volt measuring instruments must be used for checking for the absence of voltage.
Ingeteam accepts no liability for any damages caused by improper use of the equipment. Any work
carried out on any equipment which implies a modification of the original electrical arrangements
must be proposed in advance to Ingeteam. These must be studied and approved by Ingeteam.
AAX2015IQM01_ - Installation and usage manual
Ingeteam
DE
EN
ES
FR
IT
PT
37