Connection To Ingecon Units - Ingeteam INGECON SUN ComBox Manual De Instalacion Y Uso

Ingeteam
USB
Ethernet

9.2. Connection to INGECON units

The RS-485 output to INGECON units corresponds to connector 4 of the INGECON SUN ComBox. Connect as
shown in the following figures.
Pin
1
2
3
4
* Terminal to facilitate the connection.
The INGECON SUN ComBox base plate jumper JP5 enables the end of line resistor to be connected to the RS-485
bus. This jumper must be closed whenever the device is considered end of line.
50
Use a type-A or type-B USB cable (not supplied by Ingeteam)
Use an Ethernet network cable (not supplied by Ingeteam)
Signal
RS-485 B(+)
RS-485 A(-)
Protection shield*
GND
Local connection of the INGECON SUN ComBox
AAX2015IQM01_ - Installation and usage manual