Dascom Tally T2380 Guia De Instalacion página 18

Control panel operation
16
Press the < (2) or > (3) buttons until the cutting position is just below the perfo-
ration (in our example we chose a negative value; this means that the cutting line
is being repositioned to be higher). After completing the adjustment save your set-
tings by pressing the Set (1) button.The printer now performs a form feed and cuts
the paper at the position you have adjustet.
Then leave the selection menu by pressing the Setup button.
Carry out a few trial cuts. If you're not satisfied readjust the cut position again.
STOP
Do not cut the paper above the perforation as the optimal paper flow may be ad-
versely affected by the paper remaining above the perforation.
Now the cut position has been set and your printer will always cut fanfold paper at
the set position.
The printer is Online again and can receive computer data.
When the printer is initialised (e.g. when turning it on), the cut device is detected.
The standard printer's Tear function is replaced by the Cut function. The "Tear"
and "Cut"functions are identical. However, the cut device will always cut when
the cut position is reached. All the Escape sequences and menu settings connected
with the "Tear"function apply to the "Cut" function when the cut device installed
(see also Additional menu parameters in this manual).
Should you have problems installing or operating the automatic cut device, your
STOP
dealer will gladly help you.
Quick start guide