Aed Parameter - Dascom Tally T2380 Guia De Instalacion

Quick start guide Control panel operation

AED parameter

If you use different paper ways it is possible that minor divergences of the adjusted
cut position occur when switching between the paper ways. You can eliminate
these divergences from the adjusted cut position by means of the parameter AED
in the advanced menu of the printer.
This function is not available on some printer models.
To synchronize the paper after loading the sensor checks the left transport hole of
the loaded paper. If the printer by any reason cannot detect this hole, the AED
function is being disabled and "AED Error" is displayed. The printer will go
Offline, but can be set to Online again by pressing the Online key. As soon as a
new paper is loaded (e.g. by switching the paper way, by paper end etc.) the cut
edge will be re-detected.
To activate the parameter AED, which is switched off by default, proceed as fol-
lows:
First set to printer to advanced menu mode by pressing the Online key while
switching on the printer.
The display shows Test mode for about 1 second and then ASCII 80 ASCII 136.
Press the Next key (4) several times until the AED parameter appears in the dis-
play.
Press the AED key (3) .
APW AED
Set Exit
Online
1 2 3 4
Setup
19