Synchronizing The Cut Position When Using Different Paper Ways; Sync.LAbel Parameter - Dascom Tally T2380 Guia De Instalacion

Quick start guide
Synchronizing the cut
position when using
different paper ways

Sync.Label parameter

There are two different ways to synchronize the cut position: via the Sync.Label
parameter or via the AED parameter. Which function is available depends on your
printer model.
If you use different paper ways it is possible that minor divergences of the adjusted
cut position occur when switching between the paper ways. You can eliminate
these divergences from the adjusted cut position by means of the parameter
Sync.Lab in the advanced menu of the printer. In this case you have to use paper
with a black label on the back. This label is scanned after switching on the printer,
when changing paper and loading paper.
This function is not available on some printer models.
See section Technical data and Paper specifications for details about the position,
the dimensions and the density of the label.
To activate the parameter Sync.Lab, which is switched off by default, proceed as
follows:
First set to printer to advanced menu mode by pressing the Online key while
switching on the printer.
The display shows Test mode for about 1 second and then ASCII 80 ASCII 136.
Change to the parameter group Paphand by pressing the Next key (4) three times.
Press the Paphand key (2).
Control panel operation
17