Additional Menu Parameters; Setup Menu; Advanced Menu - Dascom Tally T2380 Guia De Instalacion

Additional menu parameters

Additional menu parameters

Setup menu

Advanced menu

22
After installation the cut device will be recognized automatically. Now an addi-
tional parameter is available within parameter group AutoCut (see also the corre-
sponding chapter Menu Description Table in the User Guide).
Parameter group Parameter
Auto Cut Cut on Formfeed
= ^
( Auto Tear)
After installation the cut device will be recognized automatically. Now additional
parameters are available, dependent on printer model (see section "Sync.Label pa-
rameter" on page 17 and "AED parameter" on page 19).
Which parameter is available depends on the printer model.
Parameter group Parameter
Paphand Sync.Label=On/Off
or
AED=On/Off
Quick start guide
Description
If this parameter is set the paper will be
cut automatically at next perforation after
receiving a form feed (hex. 0C, dec. 12).
Description
Allows to synchronize the cut position
when using different paper ways.
Corrects possible inaccuracies of the
paper positioning at the cut edge if the
paper path is changed after a cutting
action