D
E
S
C
R
I
P
T
I
O
N
O
D
E
S
C
R
I
P
T
I
O
N
O
Main power ON/OFF switch is located on the rear panel with a "power on" green LED indicator on the front panel.
Plug the main power cord into the back of the Infiltration Pump. Plug the other end into any AC outlet with the
same voltage as noted on your machine. The Infiltration coupler shall also be used as a separator from the
mains.
Footswitch connectors are located on the front panel, under the pump head.
Power connector is located on the rear panel of the unit.
Pump speed (flow rate) is set by a user adjustable single turn potentiometer located on the front of the panel.
The drive is a single direction with a clockwise Pump Head operation and not user selectable.
S
E
T
U
P
I
N
S
T
R
U
C
S
E
T
U
P
I
N
S
T
R
U
C
1.
The infiltration fluid, tubing, handle/ needle, and spike must be sterile.
2.
Open the pump head lid to allow loading of the peristaltic tubing/tubing section.
3.
Peristaltic tubing/tubing specifications:
Material: Silicone
4.
Place tubing on roller section ensuring flow direction is from left to right when facing the unit.
5.
Lower Pump Head lid to the down (closed) position and lock in place.
6.
Connect pneumatic foot switch tubing to ports located on the front of the pump, under the pump head.
7.
Turn power to the Klein Infiltration Pump ON.
8.
Select desired pneumatic foot switch mode (toggled or momentary) located on the back of the pump.
In toggle mode, depress foot switch to start the pump's operation. Depress again to discontinue pump
9.
operation. In momentary mode, the foot switch must be held down to enable pump operation.
10.
Adjust flow rate, as necessary, using the potentiometer speed control dial.
NOTE: Rotating dial clockwise (CW) will increase flow rate. Rotating the dial counterclockwise (CCW) will
decrease flow rate. Dial indicator numbers are relative and do not indicate a specific flow rate. Flow rate
must be empirically correlated to dial indicator number.
UMKIP Rev. N
F
C
O
M
P
O
N
E
N
T
S
F
C
O
M
P
O
N
E
N
T
S
T
I
O
N
S
T
I
O
N
S
Sizes: 3/16 in x 3/8 in OD or ¼ in ID x 7/16 in OD
- 6 -