Leister VARIANT T1 Instrucciones De Funcionamiento página 37

Leister VARIANT T1 Versions
Article no. 141.891 VARIANT T1, 230 V / 40 mm welding nozzle / with European plug
Article no. 141.892 VARIANT T1, 230 V / 20 mm welding nozzle / with European plug
Article no. 141.893 VARIANT T1, 400 V / 40 mm welding nozzle / with CEE plug (3LNPE)
Article no. 141.894 VARIANT T1, 400 V / 20 mm welding nozzle / with CEE plug (3LNPE)
Article no. 147.739 VARIANT T1, 200 V / 40 mm welding nozzle / without plug
Article no. 147.748 VARIANT T1, 200 V / 20 mm welding nozzle / without plug
Accessories
For safety and technical reasons, only Leister accessories may be used.
Article no. 142.650 Hem / Piping kit complete
Article no. 140.530 Hem / Piping add-on part
Article no. 142.221 Hold-down device
Article no. 141.326 Piping guide
Training
• Leister Technologies AG and its authorised service points offer free welding courses and training events.
Information at www.leister.com.
Maintenance
• The air inlet on the hot-air blower (8) must be cleaned with a brush if soiled.
• Clean welding nozzle (9) with brass brush.
• Check power supply cord (1) and plug for electrical and mechanical damage.
Service and Repairs
• If the drive counter reaches 400 h or the blower counter reaches 2000 h, the message
«Maintenance servicing» will appear on the display (5) the next time the main switch (3)
is switched on. This message is displayed for 10 seconds and cannot be skipped by the
controls (4).
• Repairs should only be carried out by authorised Leister service centres.
These guarantee a professional, reliable repair service within 24 hours, using original
replacement parts according to the circuit diagrams and replacement part lists.
Guarantee
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
Article no. 139.438 Additional weight
Article no. 137.843 T-handle for guide bar top
Article no. 116.798 Brass brush
Article no. 142.705 Carrying case
37