Quick Start Reference Guide
This is only a quick reference. Read the entire instruction manual prior to using the product.
Read all warnings and safety instructions in the instruction manual before use.
1
Mix your material thoroughly. For best results
it is recommended to thin paint 5-8%. Remove
and fill container with material. Use a filter to
strain material if it is old, as it may be chunky
and clog the sprayer.
4
Set flow to maximum by turning the control
knob fully counterclockwise.
7
When finished spraying, unplug sprayer.
Remove container and empty contents. Rinse
container out completely.
English
4
2
NOTE: Sprayer requires lubrication before each
use to work properly. See lubrication section on
page 14 for details.
5
Adjust the spray pattern by turning the knob
back in a clockwise direction until you have
the spray pattern you want. See page 9 for
information on proper spray pattern.
8
Fill sprayer with cleaning solution and engage
trigger until solution comes through nozzle. See
page 12 for information on latex and oil clean up
suggestions.
3
Tightly attach pick-up tube to the forward-
most port of the cylinder housing. Attach
the container filled with your material to the
sprayer and plug into outlet.
6
Spray your surface, keeping the sprayer level
and 10" to 12" from surface. Use a sweeping
and overlapping motion for best overall coverage.
9
Remove parts. Clean and dry according to
instructions on page 12. Lubricate sprayer
before storing with lightweight oil (included), or
use WD40
, 3-in-One
oil, or similar product.
®
®
www.homeright.com