Tabla De Contenido; Introduction - Greenlee Smart Bender 855 Manual De Instrucciones

Table of Contents
Introduction .................................................................... 2
Important Safety Information ...................................... 3-4
Grounding Instructions ................................................... 5
Specifications ................................................................. 6
Identification ................................................................... 7
Setup .......................................................................... 8-9
Operation ............................................................... 10-13
Illustrated Bending Glossary ........................................ 14
Bend Calculations .................................................. 15-18
Bending Tables ...................................................... 19-24
Assembly Instructions for 40 Mil PVC-coated
Rigid Bending Accessories ....................................... 25
Troubleshooting ..................................................... 26-28
Accessories .................................................................. 29
All specifications are nominal and may change as design improve-
ments occur. Greenlee Textron shall not be liable for damages
resulting from misapplication or misuse of its products.
Smart Bender is a registered trademark of Greenlee Textron.
Loctite is a registered trademark of Loctite Corporation.
Molex is a registered trademark of Molex Inc.
Greenlee Textron / Subsidiary of Textron Inc.
855 Smart Bender
KEEP THIS MANUAL
®

Introduction

Description
The 855 Smart Bender
2" EMT, IMC, rigid steel, and rigid aluminum conduit
from 0 through 90 degrees. With the optional 01700
shoe group attachment, this tool can also bend 1/2"
through 2" 40 Mil PVC-coated rigid steel conduit. The
operation of the Smart Bender is similar to other
Greenlee electric benders with the bending action
accomplished through a rotating shoe with a hook and
stationary roller conduit supports.
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
Do not make any modifications to this device.
Unauthorized changes or modifications will void the
user's authority to operate this device under United
States federal law.
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information for
avoiding hazards and unsafe practices related to the use
of this tool. Observe all of the safety information
provided.
Purpose of This Manual
This manual is intended to familiarize personnel with
the safe operation and maintenance procedures for the
Greenlee 855 Smart Bender.
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge.
Other Publications
Service Bulletin: 999 4360.3 (SB 290)
2
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070
® is designed to bend 1/2" through