Greenlee Smart Bender 855 Manual De Instrucciones página 9

Setup (cont'd)
Pivoting the Bending Head
• Do not rotate the bending head if one or more of
the bending shoes is removed.
• The bender head pivot lock must be fully engaged
in the frame hole and fully turned in the counter-
clockwise direction.
Failure to observe these warnings may cause the
bending head to move rapidly in an unexpected
direction, resulting in severe injury or death.
The bending head can be rotated into three positions:
• Vertical
• Horizontal, 1/2" to 1-1/4" shoe facing up
• Horizontal, 1-1/2" to 2" shoe facing up
To change the bending head position:
1. Rotate the bender head pivot lock knob clockwise
until it contacts the bending head.
2. Pull out the bender head pivot lock knob.
3. Pivot the bending head to the desired position.
4. Release the bender head pivot lock knob so that the
pin is fully engaged in the frame hole.
5. Turn the pivot lock knob counterclockwise until there
is resistance. Do not overtighten.
Greenlee Textron / Subsidiary of Textron Inc.
855 Smart Bender
®
Connecting the Standard or Deluxe Pendant
Do not connect or disconnect the pendant while the
power is on, or permanent damage to the pendant or
bender circuitry may result.
Remove the pendant control from its storage area, and
plug it into the four-pin receptacle on the side of the
bending head.
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070