transferred to the PC by connecting the monitor
via the USB cable. Important: your wrist
blood pressure monitor must be set to PC
LINK mode whenever the unit is in contact
with your computer. When the software
prompts you to make the connection to your
blood pressure monitor, your monitor must be in
the PC LINK mode. Push the M Button and
choose PC LINK then push the M Button again to select it. You must set your wrist
blood pressure monitor to PC LINK mode to install the software and every time you
want to download your measurements to your PC.
When the unit is in PC LINK mode you will see a series of curved lines that pulsate
from a stationary dot. Note: Software does not work with MAC computers!
7.1. Installation and Data Transmission
a) Insert CD into CD ROM drive of your PC. The installation will start automatically (If
not, click on SETUP.EXE). The software will prompt you to connect your unit to the
computer via the USB cable. The wrist unit must be in PC LINK mode.
b) To transmit data you must have stored data in the memory first. To download
memories from User 1, you must set the blood pressure monitor to User 1 prior to
downloading. To download memories from User 2, you must set the monitor to User
2. There is a User 0, which does not store memories. If your unit is on the User 0
setting, no readings will be downloaded. Remember to make sure your wrist unit is
in PC LINK mode prior to connecting to your computer.
c) You cannot take a blood pressure measurement while the unit is in PC LINK mode.
During the PC connection, the device is completely controlled by the computer. Please
refer to the 'help' file for software instructions.
Note: For problems with installation, go to Error Messages/Troubleshooting in
Section 9.
8.
Adjusting the Display Contrast
This item enables you to adjust the contrast. Scroll to Contrast and
press OK to enter the submenu. Press
contrast. Press
adjusted the contrast, press OK to confirm the setting.
Note: Do not set the contrast to the lowest setting. It will
appear blank and remain that way next time you turn it on,
rendering it impossible to see. Make only minor contrast
adjustments.
to decrease the display contrast. After you have
to increase the display
CONTRAST
15