Atlantis A11-NVR1600 Guia De Inicio Rapido página 34

N° CONNECTOR
1 Power Switch
2 Sensor
3 Alarm
4 Power Plug IN
5 RS-485
6 Ethernet Port
7 PoE Port
Output
8
HDMI/VGA
9 USB Port (front)
10 USB Port (rear)
FUNCTION
Push this button in order to switch on/off the device (not present in
all models). This Power Switch is placed on the power cord. The only
model A16-NVR1600-4K includes this switch in the rear panel.
Connect the sensor wires to the sensor slots labeled as "SENSOR"
and numbered 1~2 with a common ground "G" on the NVR. This
device often used with a security camera at the monitoring space.
Sensor ports (marked "1~2") and a common ground (marked "G").
4 Alarm IN for the models A11-NVR1608P(1600)-4K.
Connect the alarm indicator to the alarm slots labeled as "ALARM" on
the NVR. This supports alarm that can be triggered when an event
has occurred.
Connect power supply.
RS485 interface. RS-485 connector (typically for PTZ cameras and
keyboards)
 A=+
 B=-
G=Ground
Connect LAN, F/E Ethernet (RJ45)
Connect LAN, Gigabit Ethernet (RJ45). Only on A11-NVR1608P-4K
and A11-NVR1600-4K.
NetNVR 1608P/1604P/1608P-4K (with embedded 4 or 8 port PoE
Switch) uses ethernet cables for the connection to PoE cameras
(power and video/audio are integrated onto the same cable,
supporting category 5/5e up to 100 Meters).
Connect to VGA/HDMI monitor. These devices can support from
1280x1024 up to 1920x1080.
These models (A11-NVR1600-4K and A11-NVR1608P-4K) included
only HDMI output (1920x1080 and 3840x2160 30Hz).
Connect USB mouse. Some NVRs offer USB port in the Front Panel.
Connect USB device (Flash Drive, Hard Drive and Recorder etc) or a
mouse.
34
ENG