Bosch TPA 200 Manual Original página 23

5.4 Check
The sensor data of the tires can be read in the
main menu above "Check". The reading of the
sensors is always in the same sequence. One
begins at the left front, then the right front, then
the right rear and then the left rear, and finally
the sensor of the spare tire can be read.
1. Switch on the TPA 200.

Main Menu is displayed.
 Check
is displayed.
2. Confirm with .
 Vehicle >New Vehicle
(not in the case of operation sequence
"None").
i
If tests on vehicles have already been
performed and saved, and if the opera-
tion sequence is selected for "Job code",
"Registration" or "Model Year", these vehicles
can be selected again and tested.
 Select Make
3. Select " Select Make" with
confirm with .

Select Model
4. Select " Select Model" with
confirm with .
 Select Year
5. Select " Select Year" with
confirm with .
i
In the case of operation sequence
"Registration", the license number of the
vehicle to be tested can be entered before
the sensor test with
with .
 Front Left >Read Sensor
played.
Robert Bosch GmbH
is displayed
is displayed.
or and
is displayed.
or and
is displayed.
or and
or and confirm
is dis-
Operation | TPA 200 | 23
The following menu items can be selected:
Menu item Description
>Read Sensor The sensor is read.
>Req. Repair
Only select, if the sensor is visi-
bly faulty. A message about repair is
made in the test protocol. The sensor
is not read.
>Skip Wheel
The selected sensor is not read.
>Cancel Audit Return to the main menu. No data is
saved.
6. Hold the TPA 200 close to the tire valve.
 Front Left >Read Sensor
played.
7. Confirm with .
 The sensor is read and then displays the
sensor data, e.g.
2.5bar Bat:OK
ID:00001A635
i
If the sensor could not be read, repeat the
search.
8. Confirm with .
9. Read the sensors of all the wheels in accor-
dance with the given sequence.
10. Confirm with .
 Vehicle Data >Save
The following menu items can be selected:
Menu item Description
Vehicle Data
The measurement data is saved.
>Save
Vehicle Data The individual sensors can be marked
>Edit with , showing whether they should
be repaired. The message about re-
pair is then made in the test protocol.
Order numbers or license numbers
can also be edited.
Vehicle Data The measurement data is not saved.
>Exit
 Vehicle Data >Save
 Confirm with
"
The measurement data of the sensors is saved.
" Main Menu
is displayed.
1 689 989 200
en
is dis-
is displayed.
is displayed.
.
|
2014-05-08