Bosch TPA 200 Manual Original página 25

5.6 Repair
This function enables you to perform a test of
the sensors again after a repair (e.g. a sensor
has been changed).
1. Switch on the TPA 200.
 Main Menu
is displayed.
 Check
is displayed.
2. Select "Repair" with
with .
 Vehicle >New Vehicle
(not in the case of operation sequence
"None").
i
If tests on vehicles have already been
performed and saved, and if the operation
sequence is set for "Job code", "Registration"
or "Model Year", these vehicles can be se-
lected again and tested.
 Select Make
3. Select " Select Make" with
confirm with .
 Select Model
4. Select " Select Model" with
confirm with .
 Select Year
5. Select " Select Year" with
confirm with .
i
In the case of operation sequence
"Job code", the order number of the vehicle
to be tested can be entered before the
sensor test with
, and in the case of operation sequence
Registration the license number of the ve-
hicle to be tested can also be entered.
 Front Left >Read Sensor
played.
Robert Bosch GmbH
or and confirm
is displayed
is displayed.
or and
is displayed.
or and
is displayed.
or and
or and confirm with
is dis-
Operation | TPA 200 | 25
The following menu items can be selected:
Menu item Description
>Read Sensor The sensor is read.
>Req. Repair
Only select, if the sensor is visi-
bly faulty. A message about repair is
made in the test protocol. The sensor
is not read.
>Skip Wheel
The selected sensor is not read.
>Cancel Audit Return to the main menu. No data is
saved.
6. Hold the TPA 200 close to the tire valve.
 Front Left >Read Sensor
played.
7. Confirm with .
 The sensor is read and then displays the
sensor data, e.g.
2.5bar Bat:OK
ID:00001A635
i
Repeat the search, if the sensor could not
be read.
8. Confirm with .
9. Read the sensors of all the wheels in accor-
dance with the given sequence.
10. Confirm with .
 Vehicle Data >Save
The following menu items can be selected:
Menu item Description
Vehicle Data
The measurement data is saved.
>Save
Vehicle Data The individual sensors can be marked
>Edit with , showing whether they should
be repaired. The message about re-
pair is then made in the test protocol.
Order numbers or license numbers
can also be edited.
Vehicle Data The measurement data is not saved.
>Exit
 Vehicle Data >Save
 Confirm with
"
The measurement data of the sensors is saved.
" Main Menu
is displayed.
1 689 989 200
en
is dis-
is displayed.
is displayed.
.
|
2014-05-08