Bradley Smoker BTIS1 Manual Del Propietário página 6

The Black Bradley Smoker (Models: BTIS1; BTISCE240EU)
For The Original Bradley Smoker See Page 9 For 4 and 6 Rack Digital Smokers See Page 13
Refer to Part Numbers in the Bradley Smoker External Components List and Internal
How to Assemble the
Bradley Smoker®
1. Remove smoker from box.
2. Take all packaged parts out of
smoker.
3. Remove all protective packaging
materials from parts.
Install Smoke Generator:
Attach smoke generator (1) to
•
the smoker tower (2).
Aim the bisquette burner (F)
•
toward the tower opening.
Align smoke generator key holes to
•
smoker tower locating supports (3).
Secure the generator by pushing
•
down firmly.
Insert the feeder tube (4) on top
•
of the smoke generator and push
down firmly then load it with the
desired number of Bradley Flavor
Bisquettes®.
Plug the short power cord (E-not
•
shown) from the smoke generator
into the smoker tower.
Set Up Smoker Tower:
Place Racks (C) onto side
•
supports.
Place Drip Tray (B) "V" facing
•
down beneath the Racks on the
brass side pins.
Assembly Instructions
Components List Diagrams
•
the bottom of the Smoker.
•
of water and place in the center
of the Rectangular Tray to catch
burnt Bisquettes. During a long
smoking period, the Drip Bowl
will require changing the water
every 2-3 hours. Plug the Long
Power Cord (A) for the smoke
generator into an approved
grounded electrical outlet.
To Remove Smoke Generator:
•
•
smoker tower by raising the smoke
generator gently upward and pull it
outward.
All packaging should be discarded
as per the regulations in your area.
The box can be used only to store
smoker when not in use. The box
should not be used as a cover when
smoker is in use.
5
Place the Rectangular Tray (J) on
Fill the Drip Bowl (D) half full
Unplug short jumper cord (E).
Detach smoke generator from the
Handling of Packaging