Programming Instructions; Programming Overview - Signature Control Systems EZ Pro 8600 Serie Manual De Instalación Y Programación

PROGRAMMING INSTRUCTIONS

Programming Overview

The EZ Pro™ can be programmed under AC power or powered from the two AA alkaline
batteries. Before programming the EZ Pro™, it may be helpful to become familiar with some
general programming guidelines:
If a segment(s) on the LCD is flashing, it means that it can be changed by the user.
•
• When using '+'or '–' keys, hold the button three seconds to start a fast scroll.
Be sure the appropriate program letter is displayed when you are programming; program
•
changes are specific to the program letter displayed on the LCD.
There is no "ENTER" key. Key-presses and dial settings are stored automatically for you.
•
If you make a programming change while a program is running, the program terminates
•
immediately. The new program starts at the next start time scheduled.
When not running, the controller displays the current time and the current day.
•
• During manual operations, there is a 5-second delay before the operation begins. During
this time, you can change your settings. Each time you make a change, the delay resets to
5 seconds.
MANUAL, CYCLE, and 3 MINUTE TEST procedures only operate with the Program dial
•
set in the AUTO position.
After a test procedure runs, the controller reverts back to the AUTO procedure and runs
•
the next program scheduled.
The test procedures ignore the sensor connection; this allows you to water or run your
•
program even if the sensor has suspended operation.
9