Set Interval Scheduling Option; Program Review - Signature Control Systems EZ Pro 8600 Serie Manual De Instalación Y Programación

PROGRAMMING INSTRUCTIONS

Set Interval Scheduling Option

Turn the large dial to the SCHEDULE position. The last scheduling option chosen for the
current program appears on the LCD. Press SELECT '+' or '–' to scroll to the interval days
position. An arrow will appear on the LCD next to INT (Interval). Use the ADJUST '+' or '–' to
choose interval days between watering (1-30). The date displayed is day one of the interval
schedule. (Today's date if one has been set). To change day 1 date use SELECT '+' or '–' to
go to the interval start date position. As needed, change the date for day one of the interval
schedule with ADJUST '+' or '–' (can only be set up to 30 days out).
Repeat the above procedures for each program (A, B, or C), as you require.
That's it! Your EZ Pro™ is now programmed. Turn the MODE dial to the AUTO position to run
the program you entered.
NOTE: Programming an INTERVAL schedule deletes any other schedule for the selected
program.

PROGRAM REVIEW

To review the current program, Turn the MODE dial to the PROGRAM position and turn the
large dial to the setting you wish to review (i.e., turn the large dial to TIME to review the time
set for the controller). When you need to view different zones or run times (1, 2, 3), use the
SELECT '+' or '–' buttons only.
NOTE: Since you are in the program mode, the potential exists to change the program
accidentally.
17