Service And Maintenance - HPC 11500 Manual De Instrucciones

Instruction Manual Pressing Tool
11500
Attention
For your own safety please observe all local safety regulations.
The user needs to make sure that the pressing jaws are completely closed and that there are no foreign objects (e.g.
plaster or stone fragments) between the pressing jaws.
4.2 Application
This tool is meant for use with HeatLink® stainless steel press sleeves, PEX tubing, and fi ttings.
The unit is not to be restrained in a vise. It is not allowed to use the tool in a stationary application.
The tool is not designed for continuous use. After series of approximately 50 completed presses, let the tool cool
down for 15 min.
Attention
Overly intensive use can cause heat damage to the tool
Attention
During the operation of the built-in electric motor, sparks can occur, which might ignite highly infl ammable
or explosive liquids and materials.
Attention
Electric tools must not be operated in pouring rain or under water.

4.3 Service and Maintenance

The reliable operation of the tool is dependent on proper handling and service. To ensure proper presses, this tool
must be mainted and serviced regularly as follows:
1. The electric-hydraulic pressing unit must be cleaned and dried after each use before stored.
2. In order to guarantee reliable operation, the pressing tool should be returned to the manufacturer or one of our Au-
thorized Service Centers (ASCs) after the red LED indicates Service (after 10,000 pressing cycles) or once every
year whichever occurs fi rst.
3. The nuts and bolts, the rollers and their guides as well as the moveable parts of the pressing jaw must be
lightly oiled on a regular basis.
L611500 Rev. C © 05/2013 5
US