HPC 11500 Manual De Instrucciones página 7

Instruction Manual Pressing Tool
11500
Preparation
1. Inspect all components for debris, obstructions, and/or
damage prior to installation.
2. Cut the PEX tubing to length, ensuring a square cut - an
irregular cut may result in a failed connection. For larger
diameter PEX an ABS cutter is recommended.
Pure
Pure
3. Slide the stainless steel sleeve over the tubing until it is
properly seated.
Pure
Pure
4. Push the tubing and sleeve onto the fitting or Multiport tee
until it bottoms out on the shoulder.
L611500 Rev. C © 05/2013
®
Link Plus Link
®
Link Plus Link
®
Link Plus Link
®
Link Plus Link
®
Pure Link Plus Link
®
Pure Link Plus Link
5. Use the sight hole in the sleeve to verify proper seating
of PEX tubing.
6. Make press as instructions below for
" to 1 " Press Instructions; Auto Press
1 1
2 2
Never press with empty jaws as this will damage the jaws.
Regularly check tool jaws and sleeve for any abnormalities that
could be an indication of a damaged tool.
If the Stainless Steel Sleeve is damaged or pressed incorrectly,
Never re-use stainless steel press sleeves.
1. Open the jaws and position squarely around the sleeve, then
®
Pure Link Plus Link
" to 1 ".
1 1
2 2
VI