Stiebel Eltron DHB-E 11 SLi electronic Operación E Instalación página 28

Installation
Assembly
1
2
3
1 Knock-out
2 Cap guides
3 Back panel guides
10.3.8 Installing lower part of back panel
If using threaded connections for finished walls, the lower part of
the back panel can also be installed after fitting the taps/valves.
To do this, carry out the following steps:
Cut open the lower part of the back panel.
Fit the lower part of the back panel by bending it out at the
sides and guiding it over the pipes.
Insert the connection pieces from behind into the lower part
of the back panel.
Click the lower part of the back panel into place.
Secure the lower part of the back panel with a screw.
1
3
1 Back panel bottom section
2 Connection pieces from the pack
3 Screw
10.3.9 Installation in case of appliance replacement
An existing mounting bracket can be used when replacing Stiebel
Eltron appliances (except "DHF"). For this, open a suitable knock-
out in the back panel for the stud of the existing mounting bracket.
If the appliance is being installed in place of a DHF, move the
stud on the mounting bracket as shown in the diagram "Mounting
bracket for DHF appliance replacement". The stud cuts its own
groove. Then turn the mounting bracket through 180° to be mount-
ed on the wall. The logo "DHF" is then turned towards the reader.
If replacing a third party appliance, suitable holes for rawl plugs
can be used.
28 | DHB-E SLi | A electronic
2
10.3.10 Undersink installation with turned appliance cap
The appliance cap can be positioned on the back panel turned
through 180°. This particularly advantageous for undersink in-
stallation. For this take the following steps:
Remove the user interface from the appliance cap by press-
ing the locking hooks.
Turn the appliance cap and click the user interface into place,
ensuring that all locking hooks click into place. To install the
user interface more easily, press against the inner side of the
appliance cap (in the shaded area, see diagram "Appliance
cap for undersink installation").
Material damage
!
Never install a user interface with a faulty locking
hook. Otherwise the safety of the appliance cannot be
guaranteed.
Plug the set value transducer cable into the "set temperature"
PCB; see "Commissioning".
Hook the appliance cap in at the bottom and pivot it up onto
the back panel. Ensure the all-round seal of the back panel
sits tightly by pushing the cap gently forwards and back.
Close the appliance with the screw in the cap.
www.stiebel-eltron.com