Dismounting; Disposal - Binzel BRS-LCi Instructivo De Servicio

BRS-LCi

11 Dismounting

Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe the information given in section
1 Unscrew the screws and remove the cleaning unit and the collecting tray.
2 Unscrew the screws and remove the support from the bottom.

12 Disposal

For disposal, the local regulations, laws, provisions, standards and guidelines must be observed. For the
cleaning station BRS-LCi to be properly disposed of, it first must be dismounted.
 11 Dismounting on page EN-21
12.1 Materials
This product consists for the most part of plastics, steel and non-ferrous metals. Steel and non-ferrous metals
can be molten in steel and iron works and are thus almost infinitely recyclable. The plastic materials used
are marked in preparation for sorting and separation of the materials for later recycling.
12.2 Consumables
Oils, greases and cleaning agents must not contaminate the ground and not enter sewage systems. These
materials must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions of the safety data sheets given by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the manufacturer of the consumables.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
BAL.0149.0 • 2017-05-17
DANGER
 8 Putting out of operation on page EN-18
11 Dismounting
EN - 21