Preparation And Check Before Use - Toshiba RAS-M10SMUV-E Manual Del Propietário

Ocultar thumbs Ver también para RAS-M10SMUV-E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99

PREPARATION AND CHECK BEFORE USE

Loading the remote controller batteries.
a Remove the cover and insert the batteries.
b Push the RESET button.
The clock display flashes. Adjust the clock. Place back the cover.
Removing the batteries
a Remove the cover, and take out the batteries.
b Reattach the cover.
* Please dispose of the batteries according to the local regulation.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries last about one year.
• Replace the batteries if there is no beep from the receiver of the
indoor unit or when the air conditioner cannot be operated using the
remote controller.
• To avoid malfunctions caused by battery leakage, remove the
batteries when not using the remote controller for over one month.
Setting the clock
Before you start operating the air conditioner, set the clock of the
remote controller using the procedures given in this section.
The clock panel on the remote controller indicates the time regardless
of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel
indicates AM 0:00 and flashes.
a TIMER
button
Push the TIMER
button to set the current time.
Each time the TIMER button is pushed, it changes the time on one
minute basis.
When the TIMER button is held down, it changes the time on one
ten minutes basis.
b SET
button
Push the
SET button. The current time is displayed and the
clock starts.
Clock adjusting
a CLOCK button
Push the CLOCK button. The CLOCK display flashes.
b TIMER
button
Push the TIMER
button to set the current time.
Each push of the TIMER button changes the time by one
minute.
Holding down the TIMER button changes the time by ten
minutes.
c SET
button
Push the
SET button.
The current time is displayed and the clock starts.
EN
• Slide off the cover while
pushing the sides.
• Battery replacement
Be careful not to reverse the (+)
position and the (–) position.
Push CLOCK
8

Publicidad

Tabla de contenido
loading

Tabla de contenido