Timer Operation - Toshiba RAS-M10SMUV-E Manual Del Propietário

TIMER OPERATION

ON timer and OFF timer
Setting Timer
a ON/OFF TIMER button
Push the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes at the same time as the ON/OFF
TIMER display.
b TIMER
button
Push the TIMER button.
Set the timer to the desired time.
Each push of the TIMER button changes the time by ten minute increments.
Pushing the TIMER button continually changes the time in one hour increments.
c SET button
Push the SET button to set the timer.
The set time for the timer is displayed and the timer starts.
d CLR
button
Push the CLR button to cancel the timer setting.
.
CAUTION
• When you select the timer operation, the remote controller automatically transmits the timer signal to the indoor unit at the
specified time.
Therefore, keep the remote controller in a location where it can transmit the signal to the panel properly.
• If you do not push the SET
Once you select the timer operation mode, the settings are saved in the remote controller.
Thereafter, the air conditioner will start operating under the same conditions when you simply push the ON/OFF button of the remote
controller.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section "Setting the clock" on page 8 to set the clock and then set the timer.
button within 30 seconds after setting the time, the setting will be cancelled.
13 EN