Ac Voltage Measurement - koban KPA 02 Manual Del Usuario

the AC current measurement state.
• Hold the trigger, open clamp head, and clip one lead of measurement
circuit to be tested in the clamp.
• LCD will show readings.
Note:
1. Measuring two or more wires together will cause false readings.
2. The wire being measured should be centered within the clamp.
" indicates the maximum input AC/DC current is 1000 A.
3. "

AC Voltage Measurement

Warning
Electric shock hazard.
Pay special attention to avoid shock when measuring high voltage.
Don't input voltage more than AC750V RMS.
• Insert the black probe into COM jack and red probe into INPUT jack.
• Place transfer switch to AC voltage V
voltage measurement state.
• Connect the probe with voltage source or both ends of load in parallel for
measurement.
• LCD will show readings.
Note:
1. In the small voltage measuring range, the probe is not connected with the
circuit to be tested, and the meter may have fluctuating readings, which
is normal and caused by the meter's high sensitivity. When the meter
is connected with the circuit to be tested, you will get actual measured
value.
2. In the relative measurement mode, the automatic measuring range is
disabled.
3. means that maximum input voltage is 750V AC.
www.grupotemper.com
Digital clamp meter
position. Press FUNC to select AC
Instructions manual |
KPA 02
31