Automatic Power-Off; Measurement Preparation; Current Measurement - koban KPA 02 Manual Del Usuario

KPA 02
Digital clamp meter
Backlight is LED with high working current. If backlight is used often, it will
shorten battery life, so use backlight only when necessary.
Note: When battery voltage <7V, LCD displays
But when using the backlight, the battery voltage will drop due to the high
working current and the
shows, accuracy of measurement is not guaranteed). At this time, don't
replace the battery. Continue to use the meter normally without using the
backlight, and replace the battery only when the
normal use.

Automatic Power-off

• If there is no operation during any 15 minute period after turning the
machine on, the meter will enter a suspended state and automatically
power off to save the battery. Within 1 minute before shutdown, the buzzer
will sound 3 times. Immediatelyt before shutting down, the buzzer will
make a long sound.
• After automatic power-off, press the FUNC key to restore the meter to
normal function.
• Holding any other key except FUNC key and HOLD more than 2 seconds
when powering on will cancel the automatic power-off function.

Measurement preparation

• Turn the transfer switch to turn on the power. When battery voltage is low
(about <7V), LCD displays
• symbol means that input voltage or current should not be more than
the indicated value. This is to protect the internal line from damage.
• Place transfer switch to the required measuring function and range.
• When connecting line, please connect the common test line first, then
connect charged test line. When removing line, remove charged test line
first.

Current Measurement

Warning
Electric shock hazard.
Remove the probe from the meter before measuring with current clamp.
• Place measuring switch in position A~ position. At this time, the meter is in
Instructions manual |
symbol may display. (When the
symbol. Replace the battery immediately.
30
(low voltage) symbol.
symbol
symbol shows under
www.grupotemper.com