Connect The Wiring - Tesla J1772 Manual De Instalación

Step-by-Step Installation Instructions

Connect the Wiring

Note: Consult with your local electrician or
refer to your local code for proper wire sizing
appropriate for the currents in your Wall
Connector.
Note: It is the installer's responsibility to
identify whether additional grounding is
required to ensure that local regulations are
met. Grounding must be installed at the power
source and not at the cable entry to the Wall
Connector.
Warning: Do not connect service wiring
until you have read and fully understand
the concepts described in this section. If
you are uncertain about the type of
power available at the service panel,
consult an electrician, or contact Tesla for
assistance.
1. Turn off the power.
Warning: RISK OF ELECTRIC SHOCK!
Before continuing, use a voltmeter to
ensure the power is off by confirming
that NO VOLTAGE is present at the
service wiring or terminals.
2. For top entry installation, pull the service
wiring into the top entry bracket or the
Wall Connector. Use a 1" (25 mm) cable
gland to seal the power conduit or cable.
Note: The meaning of wiring colors might
vary from country to country. Follow all
applicable national and local regulations
concerning wiring color codes.
16
The following illustration shows an
example of the wiring for the top entry
bracket.
The following illustration shows an
example of the wiring for the low profile
bracket.
3. Strip the service wires going to the
terminal block on the top entry bracket
3/4" (18 mm). Ferrules are recommended.