Display Indicators - Bushnell GOLF PRO XE Guia Del Propietario

ACTIVATING/REPLACING THE BATTERY
Remove the Posi-Thread™ battery cover by lifting the battery cover tab and then rotating the
cover counter clockwise until it is loose. Lift off the cover and set it aside.
ACTIVATING THE INSTALLED BATTERY: A CR2 battery is pre-installed in your new Pro XE.
Before using the rangefinder, remove the battery cover as described above. Remove the
red plastic protective disc (see photo, right) from the top of the battery, then replace the
battery cover.
REPLACING A LOW BATTERY: Insert a new CR2 3-volt lithium battery into the compartment
negative (flat) end first (positive end facing out towards the battery cover), then replace the
Posi-Thread™ battery cover.
Note: It is recommended that the battery be replaced at least once every 6 months.
BASIC OPERATION
While looking through the Pro XE, depress the Power/Fire button once to activate the display. If the display icons and
numbers are blurry, rotate the eyepiece in either direction until they are in focus (see "Adjusting the Eyepiece" below). Place
the aiming circle (located in the center of the display) over a target at least 5 yards away, depress and hold the Power/Fire
button down until the range reading is displayed near the bottom of the in-view display. Crosshairs surrounding the aiming
circle indicate that the laser is being transmitted. Once a range has been acquired, you can release the Power/Fire button.
The crosshairs surrounding the aiming circle will disappear once the Power/Fire button has been released (i.e. the laser is no
longer being transmitted).
Note: Once activated, the display will remain active and display the last distance measurement for 10 seconds. You can
depress the Power/Fire button again at any time to distance to a new target. The maximum time the laser is transmitted
(fired) is 5 seconds. To re-fire, press the button down again.
ADJUSTING THE EYEPIECE
The Pro XE is equipped with an adjustable eyepiece (+/- 3.5 Diopter Adjustment) that allows you to focus the display
indications/icons relative to the viewed image. Simply rotate the eyepiece until the display is in focus.
SLOPE-SWITCH TECHNOLOGY
Slope-Switch Technology lets the golfer easily turn Bushnell's patented Slope function on and off. This allows the golfer to
conveniently utilize Slope to get compensated distances around the course when they want it and have a USGA conforming
device that is legal for tournament play when they need it.

DISPLAY INDICATORS

Your Pro XE display incorporates the following illuminated indicators
(refer to display image at right):
1. Aiming Circle (surrounding crosshairs indicate laser transmission)
2. Elements Mode
3. Battery Level
4. "Play As" Distance (based on Slope/Elements)
5. Slope (% grade)
6. Line of Sight Distance
7. Visual JOLT Indicator Ring
BATTERY LIFE INDICATOR
Battery Indicator shows remaining power level:
• Full charge
• 2/3 battery life remaining
• 1/3 battery Life remaining
• Battery Indicator Blinks - Battery needs to be replaced and unit will not be operable.
ACTIVE LASER
Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has been acquired, you
can release the Power/Fire button. The crosshairs surrounding the circle will disappear once the Power/Fire button has been
released (i.e. the laser is no longer being transmitted).
4
7
6
5
1
2
3
4