Nuna pipa Manual Del Usuario página 14

•
This seat is safe to use with stability leg in use or stored for
both rigid lATCH or vehicle belt
installation.
Carrier only install
1 Place vehicle in park and on level
ground.
2 Position carrier so that child
is facing the rear of the vehicle.
Only install in a forward
facing vehicle seat. (Page 6)
3 Route the vehicle lap belt under both
lap belt guides and buckle the vehicle
belt.
or
4 Route the shoulder belt around the
back of the carrier passing through
the blue shoulder belt guide.
or
•
If you are unable to route the shoulder
belt around the back of the carrier,
use only the lap belt. Allow shoulder
belt to lay against vehicle seat back
as shown.
or
•
If your vehicle only has a lap belt,
shoulder belt will not be used.
23
5 Adjust the angle of the carrier. A rolled up towel or foam pool
noodle may be used to help adjust the amount of recline.
Angle is correct when blue line on carrier is level with ground.
6 Tighten vehicle belt while
pushing carrier firmly into
vehicle seat. lock the vehicle
belt. Refer to vehicle owner's
manual for instructions. If you
cannot lock the vehicle belt,
you must use the provided
locking clip (Page 25)
•
Refer to your vehicle owner's manual
to determine if shoulder belt will lock.
•
If necessary, connect the shoulder and lap belts with a
locking clip.
•
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
7 This belt MUST be locked to prevent movement of the lap
portion of the belt. Reveiw the following points for the use of
a locking Clip
24