Zanussi ZXL636IT Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 60
Information on acrylamides
Important! According to the newest scientific knowledge,
if you brown food (specially the one which contains
starch), acrylamides can pose a health risk. Thus, we
recommend that you cook at the lowest temperatures and
do not brown food too much.
Installation
• You must read these. The manufacturer is not respon-
sible for any injury to persons and pets or damage to
property caused by failure to obey these requirements.
• To prevent the risks of structural damage or physical
injury, installation, connection of the appliance to the
power supply and gas system, setting up and mainte-
nance must only be done by qualified personnel in
compliance with standards and local regulation force.
• Make sure that the appliance is not damaged because
of transport. Do not connect a damaged appliance. If
it is necessary, speak to the supplier.
• Only use built-in appliances after you assemble the
appliance into correct built-in units and work surfaces
that obey the standards.
• Do not install the hob over a domestic appliances if
these do not allow it.
• Install the appliance only on worktop with flat surface.
• Do not change the specifications or modify this prod-
uct. There is the isk of injury and damage to the ap-
pliance.
• Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appliance
(safety regulations, recycling regulations, electrical
safety rules etc.)
• Keep the minimum distances to other appliances and
units.
• Install anti-shock protection, for example install the
drawers only with a protective panel directly below the
appliance.
• Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant.
• Seal the appliance to the worktop with no space left
with a correct sealant.
• Prevent damage of the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
• Do not install the appliance adjacent to doors and be-
low windows. If not, hot cookware can be hit off the
hob when you open the doors or windows.
• Before maintenance, switch off the appliance and dis-
connect the appliance from the power supply.
• Before installation, make sure that the local supply
conditions (gas type and pressure) agree with the ad-
justment of appliance. The adjustment conditions for
the appliance are on the rating plate, which you can
find in the accessory bag.
• This appliance is not connected to a combustion prod-
ucts evacuation device. It must be installed and con-
nected in accordance with current installation regula-
tions. Particular attention mustl be given to the relevant
requirements regarding ventilation.
• The use of a gas cooking appliance cause heat and
moisture in the room in which it is installed. Make sure
that the ventilation in kitchen is good: keep natural
ventilation holes open or install a mechanical ventila-
tion device (mechanical extractor hood).
• More ventilation (for example opening of a window or
increasing the level of mechanical ventilation where
present) is necessary when you intensive operate the
appliance for a long time.
• Carefully obey the instructions for electrical connec-
tions. There is the risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace
the damaged mains cable with applicable cable. Speak
to your local Service Force Centre.
• The appliance must have the electrical installation
which lets you disconnect the appliance from the mains
at all poles with a contact opening width of minimum
3 mm.
• You must have correct isolation devices: line protect-
ing cut-outs, fuses (screw type fuses removed from the
holder), ground leakage trips and contactors.
Disposal of the appliance
• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido