Care & Maintenance; Error Codes - Danby DDW18D1EW Manual Del Propietário

CARE & MAINTENANCE
CLEANING
• Ensure the dishwasher is unplugged and water
lines are closed before performing any cleaning
or maintenance.
• After every wash, leave the door slightly open so
that moisture and odors are not trapped inside
the appliance.
• Only use a soft cloth and mild detergent to
clean the appliance. Never use solvents or
abrasive cleaning agents as this can damage the
appliance.
• To remove water spots from the interior of the
appliance, use a soft cloth dampened with a
small amount of vinegar.
• If the appliance will not be used for a long
period of time, it is recommended to run a
normal wash cycle with the dishwasher empty
and then leave the door open until the interior
of the appliance is completely dry. This will help
the door seals last longer and will help prevent
odors from forming inside the appliance.
• Clean the door seals with a damp sponge
regularly to prevent odors from food particles
that can become trapped in the door seal.
• It is recommended to clean the fi lter and spray
arms at least once a month.

ERROR CODES

FF - water inlet warning
• Water cannot enter the machine, check the
water inlet
F1 - overfl ow warning
• Water cannot exit the machine, check the water
drain, be cautious as water can leak from the
machine
If the appliance displays any error code, a power
reset may resolve the issue. Unplug the appliance,
wait approximately 5 minutes and then plug it back
in.
FILTER
Clean the fi lters with warm water on a regular basis
to avoid the build up of odors inside the dishwasher.
a. Micro fi lter
b. Coarse fi lter
c. Metal/plastic
1
3
SPRAY ARM
The spray arms should be periodically removed and
cleaned to remove any hard water build up.
To remove the upper spray arm hold the nut in the
center and rotate the spray arm counterclockwise.
To remove the lower spray arm gently pull it
upward.
9
2
b
a
4
c