Clean Your Coffeemaker Before Using The First Time - Mr Coffee EHXSS Serie Manual Del Usuario

• Programmable Controls:
– Clock – The clock serves as a handy kitchen clock
and allows you to set the Brew Later feature and
functions as the Freshness Timer feature.
– Freshness Timer feature – Lets you know how
long your coffee has been waiting for you.
– Brew Later – Would you like to wake up to a
fresh pot of coffee? The timer allows you to
preset when you would like the coffeemaker to
automatically begin brewing your coffee, up to 24
hours in advance.
NOTE: If you have selected any of the operating
functions, the coffeemaker will act upon the last
operation selected if the power is restored within 10
seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE
FIRST TIME
Make sure your first cup of coffee is as good as can be
by cleaning your MR. COFFEE
first use. Just follow these simple steps:
1. Wash the carafe, carafe lid and the filter basket in
a mixture of mild detergent and water. Rinse each
thoroughly (please refer to the parts diagram listed
above).
2. Replace all the parts and close the lid. Then, run a
brew cycle with water only, without adding coffee
and coffee filter.
3. When brewing is complete,
turn your coffeemaker off,
discard the water in the
carafe and rinse the carafe,
carafe lid, and filter basket.
10
Coffeemaker before its
®
Your coffeemaker is now ready to use. Enjoy it!
SETTING THE CLOCK AND DELAY BREW LATER TIME
To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and MINUTE
buttons until you reach the current time.
The AM or PM indicator will light at the
bottom of the display (Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping time
from 12:00 a.m. You must set the clock if you
want to use the Brew Later feature.
To Set the Delay Brew Later Time:
While the display is in the clock mode,
simply press the Set Brew Later button
(Figure 3) and, while the Brew Later light is
flashing, set the brew time by pressing the
HOUR and MINUTE buttons. The AM or PM
indicator will light at the left of the clock
display. (Figure 4)
Within a few seconds the display will change
to the current time.
The Brew Later Time is now set!
NOTE: To activate the BREW LATER cycle, see
the "Brewing Coffee Later" section.
To check the programmed time, push the
SET BREW LATER button. The display will
Figure 1
Figure 2
Figure 3
Figure 4
11