Clean Your Coffeemaker Before Using The First Time; Setting The Clock And Delay Brew Time - Mr Coffee JPX Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Programmable Controls:
– Clock – The clock serves as a handy kitchen clock and
allows you to set the Delay Brew feature and functions
as the FRESH BREW™ TIMER feature.
– Fresh Brew™ Timer feature – Lets you know how long
your coffee has been waiting for you.
– Delay Brew – Would you like to wake up to a fresh
pot of coffee? The timer allows you to preset when
you would like the coffeemaker to automatically begin
brewing your coffee, up to 24 hours in advance.
– Special Cleaning Cycle – Enables you to easily maintain
and clean mineral deposits from your coffeemaker.
NOTE: If you have selected any of the operating functions,
the coffeemaker will act upon the last operation selected if
the power is restored within 7 seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE
FIRST TIME
Make sure your first cup of coffee is as good as can be by
cleaning your MR. COFFEE
Coffeemaker before its first use.
®
Just follow these simple steps:
1. Wash the decanter, decanter lid, permanent filter,
water filtration, and the filter basket in a mixture of mild
detergent and water. Rinse each thoroughly (please refer
to the parts diagram listed above).
2. Replace all the parts and close the lid. Then, run a brew
cycle with water only, without
adding coffee and coffee filter.
3. When brewing is complete, turn
your coffeemaker off, discard the
water in the decanter and rinse
the decanter, decanter lid, and
filter basket.
Your coffeemaker is now ready to use. Enjoy it!
10

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and MINUTE
buttons until you reach the current time.
The AM or PM indicator will light at the
left of the display ( Figures 1 and 2).
The clock is now set!
NOTE: Pressing Brew Now/Off or Clean
buttons before setting the clock will cause
the clock to start keeping time from 12:00
a.m. You must set the clock if you want to
use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 3) and,
while the DELAY BREW time is flashing, set the
brew time by pressing the HOUR and MINUTE
buttons. The AM or PM indicator will light at
the left of the clock display. (Figure 4)
Within a few seconds the display will change
to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see
the "Brewing Coffee Later" section.
Figure 1
Figure 2
Figure 3
Figure 4
11

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido