BEFORE YOU START
WARNING
• Never install this product into a combustible enclosure. Doing so could result in fi re, property damage and
personal injury.
• Never locate the accessory under a roof or overhang, in a building, garage, shed or other such enclosed area.
• Always maintain the required clearances from combustibles as detailed. Accessories are designed for outdoor
use only. Never use in a garage, building, shed, breezeway, or other enclosed area. Do not use this equipment
under any unprotected overhead combustible construction.
• Installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, or Natural Gas and propane Installation Code, CSA B149.1, or Propane Storage
and Handling Code, B149.2, in Canada.
IF SHIPMENT ARRIVES DAMAGED
VISIBLE LOSS OR DAMAGE
Be certain any visible damage to the carton is noted on
freight bill or express receipt and signed by the person mak-
ing delivery.
FILE CLAIM FOR DAMAGES IMMEDIATELY, regardless of
extent of damage.
IMPORTANT NOTES
WHERE'S THE WIND?
When selecting a suitable location, consider important
factors such as exposure to the wind and foot-traffi c
patterns.
If you have a freestanding grill, position it so the prevailing
wind blows into the front control panel (at your back when
grilling), supporting the proper front-to-rear airfl ow.
Built-in accessories located in areas with prevailing winds
should be protected by a wind barrier.
HOW LONG IS YOUR RUN?
Keep all gas supply lines as short as possible because gas
lines lose pressure over distance and with each elbow and
tee that is added. This drop in pressure affects accessory
performance. (See INDEX: "Gas Supply Line Runs" for
further details.)
|
6
SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
CONCEALED LOSS OR DAMAGE
If damage is unnoticed until the accessory is unpacked,
nontify the transportation company or carrier immediately
and fi le a "concealed damage" claim with them. This should
be done within (15) days of the date delivery is made to
you. Be sure to hold on to the container for inspection. We
cannot assume responsibility for damage or loss incurred in
transit. (See INDEX: "Obtaining Service" for further details.)
ARE YOU "ON-THE-LEVEL"?
Proper leveling during installation is critical. An accessory
that is out of level will cause erratic burner combustion and
ineffi cient, uneven heating. A carpenter's spirit level should
be used to level the accessory both front-to-back and
side-to-side.
If the fl oor is uneven or has a decided slope, re-leveling may
be required each time you move a freestanding unit.