Maintenance And Inspection - Worthington BERNZOMATIC WK5500OX Manual De Instrucciones

MAINTENANCE AND INSPECTION

HOSE CARE AND INSPECTION
• Hoses should be kept dry at all times and kept free of debris, caustic chemicals or liquids, especially oil, grease and gasoline.
• Do not pinch, twist, puncture or pull the hoses.
• Do not pull the hoses over rough surfaces or sharp edges.
• Do not tug or yank hoses or subject to other undue forces.
• Do not places hoses near heat or in the direction of the flame.
• Prior to use, inspect the hoses to ensure that there are no tears, cuts, frays or any other signs of deterioration or damage.
Do not use the torch if you detect any such conditions.
• Visually make sure that the tip is open and unobstructed. CAUTION: Do not operate with a blocked or deformed tip. Doing
so may damage the oxygen regulation resulting in leaks or permanent damage.
ASSEMBLY
1. Before attaching the hoses to the cylinders, make sure the oxygen and the fuel valves on the hoses are OFF by turning
the knobs clockwise until the knobs stop. Hand tighten only. Do not force.
2. Thread the fuel cylinder clockwise onto the fuel hose valve (1). Hand tighten only. Do not force.
3. Thread the oxygen cylinder counter-clockwise onto the oxygen hose valve (2). Hand tighten only. Do not force.
4. Place the cylinders, while attached to the hoses, into the stand (3). Do not attempt to ignite or use the torch unless the
cylinders are secured in the stand.
5. Place the cylinder stand on a stable and level surface. Improper stand position, such as placing the stand on its side, could
cause accidental tip over leading to liquid fuel entering the hoses and causing excessively long flame or flame outage.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16