Mounting The Milling Tool; Setting Up The Clamping Position - Binzel Abicor BRS-LC Instructivo De Servicio

6 Putting into operation

6.4 Mounting the milling tool

1
Fig. 6
NOTICE
• Only use tools with a suitable width across flats when changing the milling tool. Motor protection cap

6.5 Setting up the clamping position

1
Fig. 7
 See also Fig. 4 Putting into operation on page EN-11
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling tool axis) over the BRS-LC (3)
P1 Fig. 4).
2 Approach the clamping position P2 (Fig. 4). Make sure that the cylindrical part of the gas nozzle (1) lies
evenly against the prism (2).
EN - 12
1
2
Clamping device
Mounting the milling tool
SW 21, milling tool SW 17.
Gas nozzle 2
Setting up the clamping position
milling tool
1 2
3
Prism
BRS-LC
2
3
3
Tool
3 Maintenance station BRS-LC