Setting Up The Compressed-Air Motor - Binzel Abicor BRS-LC Instructivo De Servicio

BRS-LC

6.6 Setting up the compressed-air motor

1
2
Fig. 8
 See also Fig. 4 Putting into operation on page EN-11
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the milling tool (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (4) in the lower position (stroke down).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve placed
on top (7).
7 Fasten the adjusted motor position by means of the screws (3).
8 Move the torch out the clamping device (1) and remove the distance sleeve (7) from the milling
cutter (6).
1
7
6
5
Clamping device 3 Screws
Gas nozzle 4 Guide block
Setting up the compressed-air motor
6 Putting into operation
2
3
4
5 Compressed-air motor 7 Distance sleeve
6 milling tool
EN - 13