Installing & Cleaning Cartridge Filter - ArmorAll DVTB202 0901 Manual De Instrucciones

INSTALLING & CLEANING CARTRIDGE
1
INSTALLING CARTRIDGE FILTER
1. Verify that the battery is disconnected. (Fig. 1)
2. Remove power head and place in an upside down position. (Fig. 2)
3. Install the cartridge filter over the filter cage, securing it with the retainer nut. Do not over-
tighten. (Fig. 2)
REMOVING AND CLEANING CARTRIDGE FILTER
1. Unscrew the retainer nut by turning counter clockwise. (Fig. 3)
2. Carefully hold and pull the cartridge filter up for removal.
3. Clean the cartridge filter by brushing or rinsing off the debris. (Fig. 4)
4. Install cleaned or new filter as instructed in steps 2 & 3 of INSTALLING CARTRIDGE FILTER.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter
cage.
FILTER
2 3
12
4