Operation - ArmorAll DVTB202 0901 Manual De Instrucciones

BECOME FAMILIAR WITH THE BATTERY USB POWER SOURCE
This USB power source allows a Lithium-ion battery to be used to supply power to products that
require a USB connection. Before attempting to use this 20V battery USB power source, become
familiar with all of its operating features and safety requirements.
WARNING! If any part of the battery USB power source is missing or damaged, do not
operate it! Replace the USB power source with a new one. Failure to heed this warning
could result in possible serious injury.
OPERATING THE USB POWER SOURCE
1
1. To install the USB power source, align the power source to the battery pack and slide it in until it
locks in place.
2. Do not use force when inserting the USB power source. It should slide into position and "click".
Connect the USB cable (not included) to the power supply port of the USB power source. Then
connect the other end of the cable to the device that needs charged.
3. When not using or after charging, remove the USB cable and then press the release button on
the battery to remove the USB power source.
WARNING! Use this USB power source only with the following battery model numbers:
20LB2026 and 20LB4027.
1. Use of this USB power source with any battery other than specified may cause malfunction to
the product being charged or powered.
2. Connect only devices which are compatible with the power source to the USB power supply
port (see Product Specifications). Otherwise, it may cause a malfunction in the product being
charged or powered.
NOTE:
1. The product may not supply power to some USB devices.
2. Do not insert a nail, wire, etc., into USB power supply port. Otherwise a circuit short may cause
smoke and fire.
3. On rare occasions, the device may not start charging due to the protection system to reduce
battery consumption. In that case, remove the USB cable, and reconnect it; if power is low,
remove the battery pack to charge it.

OPERATION

2
USB Ports
3
Release
Button
5