Dry Vacuum Operation - ArmorAll DVTB202 0901 Manual De Instrucciones

DRY VACUUM OPERATION

WARNING:
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN,
OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR
DUST, DO NOT VACUUM TOXIC MATERIALS.
5
9
1. Verify that the cartridge filter is securely mounted. (Fig. 5) For installation instructions see page 12.
2. Insert the hose into the vacuum port. (Fig. 6)
3. Push required accessories onto the free end of the hose. (Fig. 7)
4. Make sure the battery pack is correctly installed. (Fig. 8) For installation instructions see page 7.
5. Turn the motor on by flipping the switch to the 'I' ON position. (Fig. 9)
Once you have completed vacuuming, or when the collection tank is full, turn the motor off by
flipping the switch to the 'O' OFF position. (Fig. 10) O = OFF
6. Remove the battery. (Fig. 11)
7. Empty the collection tank into a suitable receptacle. (Fig. 12)
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION
6
10
7
11
I = ON
8
8
12