ArmorAll DVTB202 0901 Manual De Instrucciones página 6

INSTALLING & REMOVING THE HOSE
1
1. Pull the work end of the hose out of the hose storage. (Fig. 1)
2. The other end of the hose is already connected to the vacuum port; make sure it is secure.
3. This wet/dry vacuum has blowing capabilities. To use as a blower, connect the larger end of the
hose to the blower port. (Fig. 2)
INSTALLING & REMOVING ACCESSORIES
3.1
Choose the desired accessories and push onto the smaller end of the hose. (Fig. 3.1)
Note: This wet/dry vac comes with an adaptable utility nozzle. This accessory can be used as a
wet nozzle, a brush, or a pet hair rake. To use the slide-on adapters follow these instructions:
1. Choose the brush or the pet hair rake adapter.
2. With the nozzle facing up, slide the adapter onto the utility/car nozzle until it clicks into place. (Fig.
3.2)
3. To remove, press the tab on the right side of the adapter and slide it off the utility/car nozzle. (Fig.
3.3)
2
3.2 3.3
6