Configuration - Festo CP-FB13-E Manual Del Usario

3

Configuration

Caution
The node contains electrostatically sensitive compo
nents. The node will be damaged if you touch the con
tact surfaces of the plug connectors or if you do not
observe the regulations for handling electrostatically
sensitive components.
Proceed as follows when configuring:
1. Switch off the power supply.
2. Open the switch cover.
3. Use the rotary/DIL switches to set the following
(see section 4):
4. Screw the switch cover tight again.
5. If the CP system is the first or last field bus slave, the
terminating resistor in the Festo Sub−D plug must be
activated.
Warning
S Check the measures required for putting your system
into a safe status in the event of an EMERGENCY
STOP.
Further information can be found in manual
P.BE−CP−FB13−E−.. .
16
the field bus address
the diagnostic message active/inactive.
Festo CP−FB13−E 0802e English