Preparing The Pipe - Siemens SITRANS F Serie Manual De Usuario

①
②
③
④
Figure 3-6
Note
Minimum Ltn 18 mm (0.75 in).

Preparing the Pipe

1. On a flat surface, attach the Spacer Bar to a Mounting Frame so that the Reference Hole
2. Slide the second Mounting Frame onto the other end of the Spacer Bar and align the
3. Wrap a Mounting Strap around the pipe. Make sure to position it so there is easy access
4. At the mounting location, place the Mounting Frame/Spacer Bar Assembly on the pipe so
5. Engage the end of the Mounting Strap with the Mounting Strap Adjusting Screw.
6. Slide strap under the spring clip of one of the Mounting Frames.
7. Tighten the Mounting Strap Screw enough to take up all of the slack, but not enough to
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
Optional: On larger pipes, multiple lengths
of straps can be linked together to
surround pipe
Mounting Strap positioned around
Mounting Frame
Sensor shown in the 9 o'clock position on
pipe
Mounting Frame
Reflect Mount with Mounting Frames and Spacer Bar
on the Spacer Bar fits over the metal post on the platform of the frame. Tighten the
clamping screw.
Number Index Hole with the metal post on the platform (see Figures 3-1 and 3-3). Then
tighten the clamping screw.
each other.
to the Mounting Strap Adjusting Screw.
that it rests on the top of the pipe.
prevent rotation of the assembly.
⑤
Space Bar Platform & Clamping Screw
⑥
Space Bar (Front View)
⑦
Metal Post
⑧
Mounting Strap Adjusting Screw
Ensure that the angled sides of both frames face away from
Repeat procedure for the other Mounting Frame
Connecting
3.5 Sensor Installation
.
31